Setting up a basic home or business network with a Belkin Wireless G MIMO router requires Ethernet cables and basic knowledge of how to activate the Wi-Fi antenna on your computer. Setting up and connecting to a Belkin Wireless G router is similar to creating other popular routers because the router has an Internet connection point called a WAN (Wide Area Network) and four LAN (Local Area Network) ports called hard-wired connections for the router. This makes the location of the connection ports the same as other popular models. Let’s find out the details of installing Belkin Wireless G Plus Mimo so that you can try the installation process on your own. You will require an Ethernet cable for setting up the device, so make sure you have it.
How to install Belkin Wireless G Plus Mimo?
- Plug a Cat5 Ethernet cable into the Ethernet port labeled, “Modem Connection” and then plug the other end of the CAT5 cable into the Ethernet port located on the back of the Internet modem. The port name varies depending on the brand of the modem, but usually, the port is labeled, “Internet”. In addition, modems have only one Ethernet port to locate it is not difficult.
- Connect a Cat5 Ethernet cable to the Ethernet ports located on the rear side of any desktop computer that you want to “hard-wire” to connect to the router. Now, you will have to connect the other end of the Ethernet cable to one of the network ports on the back of the router. If the computer is a stationary desktop computer, hard-wire it to the router, even if the computer has free Wi-Fi capability. A hardwire connection experiences minus internet connections dropped back from a free Wi-Fi connection.
- Enable the Wi-Fi antenna on all portable computers that you want to connect wirelessly to the router. The process for transforming Wi-Fi is different for each brand of computer and each operating system you use. With the Wi-Fi antenna on, scan to your network to connect to the Internet.
Now, launch a web browser to check if you are able to access any website or not. You definitely will be able to access the internet after following the steps, but in case, that doesn’t happen, then don’t be disappointed. Just go through the steps again to find if there is any fault in the steps, which you may have done by mistake. If you are able to find the error, then great, but if not, then, you should get in touch with the Router Help, as they will be able to assist you with this matter in the most suitable way.For more information go to Belkin Extender Setup.